OUYA Game Console Enclosure by MakerBot - Thingiverse

All parts were designed and tested using MakerBot PLA Filament, but may print successfully using ABS.

Case, Lid, & Spring
Infill: 10%
Shells: 1 shell (total; so 0 extra shells)
Layer height resolution: 0.20-0.25 mm

Button (use a translucent color)
Infill: 0%
Shells: 50 (fifty!)
Layer height resolution: 0.3 mm. Turn the active cooling fan ON.

Instructions:
Slot the Button into the spring from the smooth side (the side that printed against the build plate), then give the button a quarter turn to lock it in place.

Slot the long spring arm into the lid (it will only fit one way) and gently work the other two spring arms into their slots. Make sure you don't bend the spring too far in any direction. Make sure the button can move freely and isn't catching anywhere.

Slot the OUYA hardware into the printed case.

Align the two forked guides on the inside of the lid with the OUYA board and press the lid onto the case. It should seat with a satisfying snap.

Source: http://www.thingiverse.com/thing%3A66411

nba all star weekend malin akerman jeff carter chomp national enquirer kate gosselin helicopter crash